RAM 6000 Informazioni Techniche Pagina 164

  • Scaricare
  • Aggiungi ai miei manuali
  • Stampa
  • Pagina
    / 211
  • Indice
  • SEGNALIBRI
  • Valutato. / 5. Basato su recensioni clienti
Vedere la pagina 163
Software Manual 164
Automation Tab
Counter: This option will be available when Input Mode supports counters. When the checkbox is checked, the coun-
ter mode is enabled. The Count Value Size, Counter Mode and CNT Starting Address become available and must be
configured as well. The counter value is stored in the CNT IODB address.
Count Value Size: This is a plain counter mode that is either 16 or 32-bits in size, which counts on positive edge or neg-
ative edge depending on the polarity bit.
16-bit Count Returned: When this option is selected, the count will increment in a single register from 0 to 65535, then roll
over to 1 and continue to count upward again.
32-bit Count Returned: Select this option to use two (2) consecutive 16-bit registers as one 32-bit register. When the first reg-
ister rolls over to 1, the second register begins counting at 65536 (second register is most significant) and continues counting
upward in 32-bit mode.
Note: Two (2) consecutive registers are always allocated in the “CNT IODB/Modbus Address” column whether set for 16-bit or 32-
bit mode. Therefore, when using 16-bit Count Returned option, the second register should be ignored.
Counter Mode: When this option is selected, the counter mode must also be selected. If the 16-bit Counter Returned
is selected, the analog input register increases from 0 to 32767, then -32768 to 0. If the 32-bit Count Returned is
selected, the long integer input register increases from 0 to 4.2949673E9, then -4.2949673E9 and back to 0. The menu
selections for this options are listed below:
Note: When the Input Mode is set to Slow Response (filtered) some of the Counter Mode options are not particularly suited since
the maximum count is 10Hz. For example, Frequency Rate 0.1s would only be capable of measuring one count.
Up: Upward accumulator of input pulses
Run time sec: This is the on-time timer feature that counts the time the associated input is in the ON state. The output for
this option is in seconds.
Run time min: This is the on-time timer feature that counts the time the associated input is in the ON state. The output of this
option is minutes.
Freq. Rate: Depending on the frequency rate selected, the pulses are accumulated for 100ms, 200ms, 500ms, 1 second, 2
seconds, 5 seconds, 10 seconds, 30 seconds, 60 seconds or 60 minutes.
ON Pulse Width: Width time is ms between consecutive leading (OFF to ON) and trailing (ON to OFF) edges.
OFF Pulse Width: Width time is ms between consecutive leading (ON to OFF) and trailing (OFF to ON) edges.
Pulses longer than the maximum size allowed by the register will result in an overflow condition (full scale 16-bit
value equal to 65535)
Pulses shorter than 1ms will not be accurately detected resulting in erroneous values.
If no edge is ever detected by an input, the result will read as $0000. Timing only begins when an edge is detected.
Note: Counters are volatile (they will forget their counts if power is lost). Typically, retention of the values and resetting the counts
is accomplished in software at the host computer that polls these inputs.
CNT Modbus Address: Configuration must be sequential, CNT addresses are sequential by two registers from the base
address.
Vedere la pagina 163
1 2 ... 159 160 161 162 163 164 165 166 167 168 169 ... 210 211

Commenti su questo manuale

Nessun commento

Advantech MIC-3358 manuály

Uživatelské manuály a uživatelské příručky pro Procesory Advantech MIC-3358.
Poskytujeme 1 manuály pdf Advantech MIC-3358 ke stažení zdarma podle typů dokumentů: Uživatelský manuál


Advantech MIC-3358 Uživatelský manuál (84 strany)


Značka: Advantech | Kategorie: Processors | Velikost: 3.14 MB |

 

Tabulka s obsahem

MIC-3358

1

User’s Manual

1

MIC-3358 User’s Manual ii

2

Packing List

4

Caution!

4

Contents

5

MIC-3369 User’s Manual viii

8

Hardware

9

Configuration

9

1.1 Introduction

10

1.2 Specifications

11

MIC-3358 User’s Manual 4

12

5 Chapter 1

13

1.3 Functional Block Diagram

14

1.4 Jumpers

14

1.4.2 Clear CMOS (JP4)

15

1.5 Connectors

16

11 Chapter 1

19

Note: Pin 1-2 handle closed

20

Pin 1-3 handle open

20

Note: Handle closed is normal

20

13 Chapter 1

21

MIC-3358 User’s Manual 14

22

15 Chapter 1

23

MIC-3358 User’s Manual 16

24

17 Chapter 1

25

MIC-3358 User’s Manual 18

26

PS: X means either ON or OFF

27

MIC-3358 User’s Manual 20

28

21 Chapter 1

29

1.6 Safety Precautions

30

23 Chapter 1

31

1.8 Software support

32

Connecting

33

Peripherals

33

MIC-3358 User’s Manual 26

34

27 Chapter 2

35

Port Address Default

35

COM1 3F8, 3E8 IRQ4

35

COM2 2F8, 2E8 IRQ3

35

2.9 Card Installation

36

29 Chapter 2

37

MIC-3358 User’s Manual 30

38

Driver Setup

39

Chapter 3 Driver Setup

40

3.3.1 Windows 2K Driver

41

Figure 3.3: Select: Next

42

Figure 3.6: Select: No

43

Figure 3.8: Click: Have Disk

44

Figure 3.10: Click: OK

45

Figure 3.11: Click: OK

46

Figure 3.12: Click: Yes

46

Figure 3.13: Click: Next

47

Figure 3.14: Click: Finish

47

Figure 3.15: Click: Yes

48

3.3.2 Windows XP Driver

49

Figure 3.19: Click: Next

50

Figure 3.20: Click: Yes

50

43 Chapter 3

51

MIC-3358 User’s Manual 44

52

45 Chapter 3

53

Figure 3.27: Click: Next

54

Figure 3.28: Click: Finish

54

47 Chapter 3

55

MIC-3358 User’s Manual 48

56

Award BIOS Setup

57

Chapter 4 Award BIOS Setup

58

4.1.2 Standard CMOS Setup

59

55 Chapter 4

63

MIC-3358 User’s Manual 56

64

4.1.5 Integrated Peripherals

65

MIC-3358 User’s Manual 58

66

59 Chapter 4

67

Source connected CMM

67

PCF8584T MIC-3924B

67

4.1.6 Power Management Setup

68

61 Chapter 4

69

4.1.8 PC Health Status

70

4.1.9 Load Optimized Defaults

70

4.1.10 Set Password

71

4.1.11 Save & Exit Setup

71

4.1.12 Exit Without Saving

71

MIC-3358 User’s Manual 64

72

Watchdog Timer

73

Appendix A Watchdog Timer

74

67 Chapter A

75

MIC-3369 User’s Manual 68

76

Pin Assignments

77

Appendix B Pin Assignments

78

B.2 J2 Connector

79

B.3 J3 Connector

80

B.4 J5 Connector

81

B.5 System I/O Ports

82

B.6 Interrupt Assignments

83

B.7 1st MB Memory Map

83

MIC-3358 User’s Manual 76

84





Další produkty a příručky pro Procesory Advantech

Modely Typ Dokumentu
MIC-3369C Instalační příručka   Advantech MIC-3369C Installation guide, 161 stránky
PCA-6188 Uživatelský manuál   Advantech PCA-6188 User`s manual, 124 stránky
SOM-5786 Uživatelský manuál   Advantech SOM-5786 User manual, 32 stránky
MIC-3369C Uživatelský manuál   Advantech MIC-3369C User`s manual, 86 stránky
EVA-X4300 Uživatelský manuál   Advantech EVA-X4300 User manual, 58 stránky
PPC-6150A Uživatelský manuál   Advantech PPC-6150A User manual, 80 stránky
PPC-6170A Uživatelský manuál   用户手册PPC-6150A/6170A, 74 stránky
SOM-5786 Uživatelský manuál   1 - Fortec AG, 49 stránky
AIMB-203 Uživatelský manuál   Advantech AIMB-203 User manual, 122 stránky
SOM-5786 Uživatelský manuál   SOM-5786 - Octopart, 3 stránky